www.EnfoStuff.com Forum Index
Google
www.EnfoStuff.com
Forum for all North American English and European Ford Owners
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 


Vent Window Mk 2

 
Post new topic   Reply to topic    www.EnfoStuff.com Forum Index -> Technical Discussion
View previous topic :: View next topic  
Author Message
Kiwi Cortina



Joined: 20 Dec 2011
Posts: 273
Location: Novato Ca

PostPosted: Sun Mar 29, 2015 12:26 am    Post subject: Vent Window Mk 2 Reply with quote

Has any pulled the handle off a front vent window. I can get the handle off but not the shaft that goes thru the glass. Any suggestions would be appreciated.
Back to top
View user's profile Send private message
peteleo



Joined: 24 Aug 2008
Posts: 891
Location: San Mateo,California

PostPosted: Sun Mar 29, 2015 7:58 pm    Post subject: Reply with quote

After removing the pin and handle. The chrome holding ring is press fitted on the shaft and can be removed with a small puller. Most likely the seals are worn or gone so the claws of the puller should fit nicely behind the holding ring.
Back to top
View user's profile Send private message Send e-mail
peteleo



Joined: 24 Aug 2008
Posts: 891
Location: San Mateo,California

PostPosted: Sun Mar 29, 2015 8:05 pm    Post subject: Reply with quote

This procedure is for the MK2 '67-10/69. After 10/69 the holding ring screws off.
Back to top
View user's profile Send private message Send e-mail
Kiwi Cortina



Joined: 20 Dec 2011
Posts: 273
Location: Novato Ca

PostPosted: Sun Mar 29, 2015 10:51 pm    Post subject: Reply with quote

Thanks Pete. Even though its a 70 I don't think it screws off due to the ring having a flat edge where it goes against the window trim. With a new seal in place the ring wouldn't be able tighten up. I will try with a small puller.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.EnfoStuff.com Forum Index -> Technical Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group