www.EnfoStuff.com Forum Index
Google
www.EnfoStuff.com
Forum for all North American English and European Ford Owners
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 


anglia clutch releas bearing holder

 
Post new topic   Reply to topic    www.EnfoStuff.com Forum Index -> Technical Discussion
View previous topic :: View next topic  
Author Message
dlh98370



Joined: 13 Feb 2009
Posts: 53
Location: United States

PostPosted: Sun May 21, 2017 9:36 am    Post subject: anglia clutch releas bearing holder Reply with quote

Does anyone know what the bore is of an Anglia clutch release bearing holder? And is it the same as 200e/Mexico. Some research indicates that the clutch forks are the same other than the Mexico on seems to be reinforced.
dlh98370
Back to top
View user's profile Send private message
peteleo



Joined: 24 Aug 2008
Posts: 891
Location: San Mateo,California

PostPosted: Sun May 21, 2017 6:20 pm    Post subject: Reply with quote

Just measured the T/O bearing s retainers:

Anglia 105E retainer collar dia. ( where the bearing sits on ) 1.368"
Which uses a flat surface T/O bearing.

Cortina MK2 1600 retainer collar dia 1.508". Semi-round T/O bearing.

I believe the Mexico uses the 105E bell housing and modified 105E fork.
The 105E and Mexico use the same T/O bearing. Don't know if they share the same carrier.
Back to top
View user's profile Send private message Send e-mail
dlh98370



Joined: 13 Feb 2009
Posts: 53
Location: United States

PostPosted: Sun May 21, 2017 6:40 pm    Post subject: Reply with quote

I need to no the bore of the carries so I can figure out if I can machine the T9 tower/seal assembly to suit the Anglia/mexico carrier.
dlh98370
Back to top
View user's profile Send private message
peteleo



Joined: 24 Aug 2008
Posts: 891
Location: San Mateo,California

PostPosted: Sun May 21, 2017 7:40 pm    Post subject: Reply with quote

Carrier I.D: 1.20" for 105E.
Back to top
View user's profile Send private message Send e-mail
dlh98370



Joined: 13 Feb 2009
Posts: 53
Location: United States

PostPosted: Mon May 22, 2017 11:19 am    Post subject: Reply with quote

Thanks very much
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.EnfoStuff.com Forum Index -> Technical Discussion All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group