www.EnfoStuff.com

Thank you!!
Much happier with that.

95% done with the engine bay! And I'm super happy with the results. Mostly just have to make up and assemble the new fuel line pieces from the FPR to the carbs as well as throw the ignition system back on. It's amazing how much room the intake runners and carbs take up. I used the gold heat shield t...

Nearly there! More bits getting back into the bay again, the wiring harness and aux wires are all protected and fastened out of harms way. The radiator top tank got a nice coat of paint to match all of the rest of the clean and shiny parts The blue hose left of the head goes to the WRC heater, I wil...

Tank is in, pump and lines are ran, just getting all of the wiring inside of some protective looming. https://i.imgur.com/bzfeQtJh.jpg Interior lines ran and more protective looming on all the electrical cables. https://i.imgur.com/pPMvpwJh.jpg Fuel line ran through a new location, and looming getti...

Getting there, running wire loom protection on all of the misc. wires that were not very well protected in the past. Oil cooler hooked back up, but plenty of parts to still go back in in the bay. https://i.imgur.com/pI46oueh.jpg To help with the heat stress of a few bits, I ran carbon wrap on the he...

Holy Moly!!

Looks to be a great show!!!
Post up some pictures if you get the chance.

That Cortina is lovely

Welcome Ray!!!
Nice collection of cars!
I'd love to see more pics.

Without a doubt! The engine was specifically built to run high RPM on loose surfaces, so the wheels are normally moving quick no matter how slow the car is going. :lol: I took the rock chipped upper strut bar and gave it a nice reset, in matching white. https://i.imgur.com/GVchzuTh.jpg The very tire...

It's very aggressive, and not very street friendly....but I don't care, as it wasn't built for that and have fun with it regardless. The car can't get out of it's own way at anything below 3000 rpm, but when it hits it, it snaps you back into the seat until the next gearchange and just pulls super h...

BUSY week. Welcome to 2022.
Engine bay repainted to match the rest of the car, engine back in.
Nothings is connected, so loads more work to do.


A great change to do a valve adjustment, with everything out of the way!

Festivus is always included! Hahaha.

If you celebrate any kind of holidays over this time of year...have a great one!
If you don't, no problem.
Here's just an Escort with lights on it!

Engine bay was stripped and degreased...twice. Primed and a few coats of the white epoxy Ive been using everywhere else. https://i.imgur.com/bvEnTT4h.jpg These fittings are great! Kind of a challenge to do over and over again, but worth it so far.. https://i.imgur.com/mlntF42h.jpg The original Chass...