www.EnfoStuff.com

I'll send you a few tomorrow. Pete

Brent,

Got good used ones i can send you.

Pete

This site should answer all the questions regarding MK2 front suspension swap to 105E.

http://www.miltonrace.co.uk/

There's quite a lot of info on the advantages / disadvantages of EV from what I've read it's mainly the manufacturing process of the batteries are harmful to the environment. Copied: " Electric cars have their own dirty little secret: Every electric vehicle, and most hybrid vehicles, rely on la...

I believe this has been posted before. Just fun to post again. It's been calculated that the production of 1 new motor vehicle produces roughly the same green house gases ( if you believe the AGW crap ) as an average older car in reasonable tune produces in TEN Years of daily use. The design life of...

Most likely paint shops won't have the old paint mix formulas anymore. Nowadays they can exactly match the original paint by taking a photo of the dash or inner trunk lid.

Welcome, Iwan. We exchanged messages a day or so ago. Forgot to ask if the Estate has the original engine still, maybe a 105E 997 ?

Good luck,

Pete

There was quit a lot of interest in this car. I think 24K would be a reasonable offer considering it has some paint issues.

Welcome to the forum and Congrats on your new dream car. Good choice.

As Brett says, Ford dealer option for a German Ford ? Covers are made to fit the lamps. They look vintage.

https://www.ebay.com/itm/Bosch-Halogen- ... SwypZb2KUg

Hi Jim, Boiling point of water is 212F for every 3 psi is raised 1 degree F of additional pressure. Typical modern car normal cap is ~15psi will hold water in the system to ~260F. Adding ethlene or propylene glygol to water based coolant has to withstand temps below 32F or when its boiling point has...

4 lbs caps were sufficient when only water was used as coolant and compression ratio ~7:1. Nowadays all engines use mixture of water / coolant which increases thermal pressure and prevents rust accumulating in the system and lubes the w/pump seal. Though 4 lbs cap would still be ok on a standard 100...

I would always try purchasing in the States first. Ken at Dave Bean or ebay. Yesterford, Au has kits @ $75AU ea. Newfordspares: Ball joint set 204 pds.
Graeme at EnFord spares NZ. Prices vary considerably.

Don't see original bellow types that often though they are still made. Easier to purchase a modern type 160F / 72C degree Stant 45356.

Fred,

Just to clarify. Some 100E/300E models used the 4 lbs 1" reach caps EOA-8100A.