Roller Rockers for Kent Pushrod Motors

Post Reply
craigchima
Posts: 2
Joined: Tue Jan 07, 2020 10:01 am

Roller Rockers for Kent Pushrod Motors

Post by craigchima » Fri Jan 10, 2020 2:24 pm

Hello,

I am going to be making a run of 1.53 (stock ratio) roller rockers for pre-crossflow and crossflow motors and wanted to test the waters for interest in them. For the past 20+ years I have been using the Titan roller rockers but the supply of these has now dried up and there is seemingly no decent cost-effective alternative. These roller rockers will be available as "rockers only" in order to fit your stock shaft and pedestals, or as "complete assemblies" including new hardened shafts, billet pedestals, spacers, and roller rockers. I am trying to gauge how big of a run to produce so if any interest please email me directly. Craig Chima, CC Motorsports, Akron, OH, USA. (330) 807-0742 or chima97@aol.com

Langlia
Posts: 584
Joined: Mon Dec 14, 2015 11:04 pm
Location: Langley BC

Post by Langlia » Sat Jan 11, 2020 12:25 pm

Emailed

Post Reply