Finally making progress on the Prefect

enfoprefect · Post by **enfoprefect** » Mon Jan 09, 2017 12:00 pm

I moved my shop in the last few months to a place where I hope to be inspired to get moving again. I tried to get the Prefect ready to drive to the new location. Several serial problems prevented that so had to tow it anyway. Since then, I have built a temporary driver's seat and actually drove it around the block. See photo of seat. The proper seat is fully upholstered and I won't put it it the car until after painting and reinstalling window glass. I can't say the seat is very comfortable but at least it allows me to move the car around the shop under its own power.

Post by **IFHP** » Mon Jan 16, 2017 3:14 am

Thanks for sharing Bayless. Glad that you have some progress.

enfoprefect · Post by **enfoprefect** » Mon Jan 16, 2017 10:35 am

Thanks Michael. There's actually more progress than that. I have the seats about 90% finished, a complete new wiring harness installed and all new glass ready to install but waiting until after paint. Everything except the outer skin is finished from the firewall forward. I will get it up on jack stands this week to finish the underside from there back.