How is the metal air cleaner housing attached to the Weber carb? I have seen 4 threaded studs fit to the carb but I have threaded (5MM) holes which I have used socket screws drilled for safety wire. My concern that the screws could loosen and be ingested into the engine.
Thanks
Bob
Cortina MK2 air cleaner
lock tabs
I would appreciate a photo.
I am piecing this together. The engine did not have the air cleaner.
The studs that are on a spare carb (only 3) have an unthreaded portion at the carb "flange" is there a spacer that goes between the carb body and the air cleaner case?
Thanks
Bob
I am piecing this together. The engine did not have the air cleaner.
The studs that are on a spare carb (only 3) have an unthreaded portion at the carb "flange" is there a spacer that goes between the carb body and the air cleaner case?
Thanks
Bob
parts
Pete
I am interested. Is the rubber bush with spacer inside set against the air cleaner housing followed by the washer then the lock plate and finally the nut.
This is for a MK2 around 1968.
Let me know the cost and preferred method of payment.
Thanks Bob
I am interested. Is the rubber bush with spacer inside set against the air cleaner housing followed by the washer then the lock plate and finally the nut.
This is for a MK2 around 1968.
Let me know the cost and preferred method of payment.
Thanks Bob