Page 1 of 1
anglia clutch releas bearing holder
Posted: Sun May 21, 2017 9:36 am
by dlh98370
Does anyone know what the bore is of an Anglia clutch release bearing holder? And is it the same as 200e/Mexico. Some research indicates that the clutch forks are the same other than the Mexico on seems to be reinforced.
dlh98370
Posted: Sun May 21, 2017 6:20 pm
by peteleo
Just measured the T/O bearing s retainers:
Anglia 105E retainer collar dia. ( where the bearing sits on ) 1.368"
Which uses a flat surface T/O bearing.
Cortina MK2 1600 retainer collar dia 1.508". Semi-round T/O bearing.
I believe the Mexico uses the 105E bell housing and modified 105E fork.
The 105E and Mexico use the same T/O bearing. Don't know if they share the same carrier.
Posted: Sun May 21, 2017 6:40 pm
by dlh98370
I need to no the bore of the carries so I can figure out if I can machine the T9 tower/seal assembly to suit the Anglia/mexico carrier.
dlh98370
Posted: Sun May 21, 2017 7:40 pm
by peteleo
Carrier I.D: 1.20" for 105E.
Posted: Mon May 22, 2017 11:19 am
by dlh98370
Thanks very much