Does anyone have experience with adding 3 Point Belts in a Cortina Mark 1.
Is there an anchor in the B-Pillar?
Cortina Mark 1 Seat Belt 3 Point
I did some in my Anglia.
Nothing to mount to on my B pillar, not sure how you would do it anyways without cutting and welding.
I had a reinforced bolt hole to the rear of my B pillar below the side windows that I used. Got securon 3 points from the UK and they threaded right in. I drilled a new hole through the chassis rail for the roll up mechanism to sit as upright as possible so it retracts. My rear seats sit over top to cover it.
Used the original lap belt holes near the door for the other anchor point and drilled two new ones through the trans tunnel for my seatbelt releases. Reinforced with plates on the other side.
Sitting In the car the belt coming over the shoulder comfortably at no extreme angles. 0-10° max.
Just need to get creative.
Sorry have no pictures of them right now.
Nothing to mount to on my B pillar, not sure how you would do it anyways without cutting and welding.
I had a reinforced bolt hole to the rear of my B pillar below the side windows that I used. Got securon 3 points from the UK and they threaded right in. I drilled a new hole through the chassis rail for the roll up mechanism to sit as upright as possible so it retracts. My rear seats sit over top to cover it.
Used the original lap belt holes near the door for the other anchor point and drilled two new ones through the trans tunnel for my seatbelt releases. Reinforced with plates on the other side.
Sitting In the car the belt coming over the shoulder comfortably at no extreme angles. 0-10° max.
Just need to get creative.
Sorry have no pictures of them right now.
-
- Posts: 455
- Joined: Tue Dec 20, 2011 7:54 pm
- Location: Novato Ca