A few things I've learned so far, Plus question on mix screw

Post technical questions here.
Post Reply
Elan
Posts: 39
Joined: Wed Apr 03, 2019 12:17 pm
Location: Florida

A few things I've learned so far, Plus question on mix screw

Post by Elan »

So a few things I've leaned so far about my 101. I replaced the headlight switch with one I got from SmallFordSpares. The mounting threads were too short so I had to dremel the surface of the switch body to get enough threads to screw the bezel on, which is now holding on by a thread. Whatever works, it's a nice switch. I got a carburetor [thanks peteleo] and while rebuilding it found a crack half way around the venturi tube, in the same place as the carb I was replacing. A common problem I guess. So I didn't try to remove the screw, just sprayed through it. So running again but the mixture screw makes no change. Is it due to the crack? Any ideas?
Faster faster
Post Reply