Hi all,
Just put the GT style intake onto my crossflow along with a 32/36 Weber. Crank gases run to valve cover then to the intake manifold above the water port. Should it run into the carb first so it doesnt upset the AFR or this doesnt matter since it's just oil vapour?
PCV Recirculation
1600 Crankcase has a baffled cannister with a metal PCV valve on top attached hose to the inlet manifold.
Attach only a outlet tube from the crankcase to the valve cover allows by pass fumes plus residual oil to enter which is ok. A tube from the valve cover outlet
to the inlet manifold requires a baffled valve cover from the 1500 pre-c/f to avoid oil being sucked into the inlet.
It will effect the air fuel ratio. I don't remember if you adjust the carb a bit more lean or rich.
Attach only a outlet tube from the crankcase to the valve cover allows by pass fumes plus residual oil to enter which is ok. A tube from the valve cover outlet
to the inlet manifold requires a baffled valve cover from the 1500 pre-c/f to avoid oil being sucked into the inlet.
It will effect the air fuel ratio. I don't remember if you adjust the carb a bit more lean or rich.