Page 1 of 1
Refurbished steering wheel
Posted: Thu Mar 05, 2009 8:40 pm
by enfoprefect
Took a short break form the wiring project to rebuild the old steering wheel. This is what if looked like before.
and this is after.
Posted: Thu Mar 05, 2009 10:09 pm
by stanchfi
Nice, what was your method?
-James
Posted: Sun Mar 08, 2009 10:15 am
by enfoprefect
Hi James. I started with the Dremel, grinding out all the cracks to make room for filler. Then filled all those with PC-7 epoxy and sanded smooth to 220 grit. Next was 2 or 3 coats of PPG K200 urethane primer/surfacer and sanded that to 600. I used the horn button for a paint match and a friendly store manager spent a lot of his personal time getting it as right as possible. The final paint is Matrix Systems urethane single stage, 2 tack coats followed by 2 wet coats. I don't think I will do anything else to it. I finally got a bunch of photos of the steps loaded onto Flickr.
http://www.flickr.com/photos/enfoprefec ... 28/detail/
Posted: Sun Mar 08, 2009 10:26 am
by IFHP
Bayles,
Nice job on the steering wheel and nice job on the photo documenting.
Michael
Posted: Sun Mar 08, 2009 8:05 pm
by enfoprefect
Thanks Michael. Big job but the "new look" inside makes it all well worthwhile.
Posted: Tue Mar 17, 2009 2:21 pm
by enfoprefect
I finally got the process detail photos loaded onto flickr.
http://www.flickr.com/photos/enfoprefec ... 28/detail/